1. Only operation time
2. Tooling cost
3. Only setting time
4. Both setting time and operation
Only setting time
1. Briquetting
2. Sintering
3. Pre-sintering
4. Blending
Sintering
1. Hardening of surface
2. Increased stiffness of material
3. Compressive residual stresses
4. Micro structural changes in material
Compressive residual stresses
1. clamps required
2. locators on the primary datum face
3. degrees of freedom of the workplace
4. operations carried out on the primary datum face
locators on the primary datum face
1. increases continuously
2. decreases continuously
3. decreases, becomes stable and then increases
4. increases, becomes stable and then decreases
increases, becomes stable and then decreases
1. large density
2. larger valency
3. larger chemical absorption tendency
4. large chemical weight
large density
1. density of work material
2. gram atomic weight of the work material
3. concentration of the electrolyte used
4. thermal conductivity of the work material
gram atomic weight of the work material
1. compression molding
2. transfer molding
3. injection molding
4. vacuum molding
transfer molding
1. 896.07
2. 14.93
3. 448.03
4. 53764.29
448.03
1. 0.11
2. 0.23
3. 0.30
4. 0.52
0.11