Eamcet - Physics - Fluids Test

Test Instructions :

1. The Test is 1hr duration.
2. The Test Paper consists of 30 questions. The maximum marks are 30.
3. All the questions are multiple choice question type with three options for each question.
4. Out of the three options given for each question, only one option is the correct answer.
5. Each question is allotted 1 mark for each correct response.
6. 0.25 will be deducted for incorrect response of each question.
Start Test

   Time Left : 00 : 30    : 00

An air bubble of radius 1 cm rises from the bottom portion through a liquid of density 1.5 g/cc at a constant speed of 0.25 cms-1. If the density of air is neglected, the coefficient of viscosity of the liquid is approximately, (In Pas) :

  

  

  

  

Two very wide parallel glass plates are held vertically at a small separation r,and dipped in water surface tension S.Some water climbs up in the gap between the plates. If P0 is the atmospheric pressure of water just below the water surface in the region between the two plates is

  

  

  

  

Eight spherical rain drops of the same mass and radius are falling down with a terminal speed of 6 cm-s-1. If they coalesce to form one big drop, what will be the terminal speed of bigger drop (Neglect the buoyancy of the air)

  

  

  

  

There are two holes one each along the opposite sides of a wide rectangular tank. The cross section of each hole is 0.01 m2and the vertical distance between the holes is one meter. The tank is filled with water. The net force on the tank in newton when the water flows out of the holes is: ( Density of water = 1000 kg/m3 )

  

  

  

  

An iron sphere of mass 20 x 10-3 kg falls through a viscous liquid with terminal velocity 0.5 ms-1. The terminal velocity (in ms-1) of another iron sphere of mass 54 X 10-2 kg is :

  

  

  

  

Two soap bubbles combine to form a single bubble. In this process, the change in volume and surface area are respectively V and A. If P is the atmospheric pressure, and T is the surface tension of the soap solution, the following relation is true .

  

  

  

  

The loss of weight of a solid when immersed in a liquid at 00C is .If α and β are the volume coefficients of the solid and the respectively, then the loss of weight at C is approximately

  

  

  

  

A large tank filled with water to a height h is to be emptied through a small hole at the bottom The ratio of times taken for the level of water to fall from h to h/2 and h/2 to zero is

  

  

  

  

A force is experienced by cathode rays when they pass through uniform electric field

  

  

  

  

A pipe having an internal diameter ‘D’ is connected to anther pipe of same size. water flows into the second pope through ‘n’ holes, each of diameter ‘d’. If the water in the first pipe has speed ‘V’, the speed of water leaving the second pipe is

  

  

  

  

A soap bubble of radius r is blown up to form a bubble of radius 2r under isothermal conditions. If T is the surface tension of soap solution, the energy spent in the blowing

  

  

  

  

A liquid does not wet the solid surface if the angle of contact is

  

  

  

  

A horizontal pipe of non-uniform cross-section allows water to flow through it with a velocity 1 ms-1 when pressure is 50 kPa at a point. If the velocity of flow has to be 2 ms-1 at some other point, the pressure at that point should be

  

  

  

  

A plastic tube containing few stones is floating in a tank of water. If the stones are unloaded, the water level :

  

  

  

  

A certain block weights 15N in air. But it weighs only 12N when completely immersed in water. When immersed in another liquid, it weighs 13N. The ratio of relative density of the block and the liquid

  

  

  

  

Note:
  • Click the 'Submit Test' button given in the bottom of this page to Submit your answers.
  • Test will be submitted automatically if the time expired.
  • Don't refresh the page.