1. Orthogonal cutting of metals
2. Oblique cutting of metals
3. Both (a) and (b)
4. None of these
Oblique cutting of metals
1. Cutting tool prepares surfaces parallel to the work face
2. Chip flows over the tool face and direction of the chip flow velocity is normal to the cutting edge
3. Maximum chip thickness occurs at the middle
4. All of these
All of these
1. The cutting edge of the tool may or may not prepare a surface parallel to the work face
2. The maximum chip thickness may not occur at the middle
3. The chip flows on the tool face at an angle less than 900 with the normal on the cutting edge
4. All of these
All of these
1. Brittle material
2. Ductile material
3. Hard material
4. Soft material
Brittle material
1. Brittle material
2. Ductile material
3. Hard material
4. Soft material
Ductile material
1. Continuous chips are formed
2. Continuous chips are formed
3. Discontinuous chips are formed
4. None of these
Continuous chips are formed
1. Continuous
2. Continuous chips with build-up edges
3. Discontinuous
4. None of these
Continuous chips with build-up edges
1. Continuous chips are formed
2. Continuous chips with built-up edges are formed
3. Discontinuous chips are formed
4. None of these
Discontinuous chips are formed
1. Linear deformation
2. Shear deformation
3. Linear translation
4. None of these
Shear deformation
1. Cast iron
2. Mild steel
3. Aluminium
4. None of these
Cast iron