# The kinematic indeterminacy of the beam is

1.  5

2.  9

3.  14

4.  15

4

9

Explanation :
No Explanation available for this question

# The kinematic indeterminacy of the frame is

1.  4

2.  6

3.  8

4.  10

4

8

Explanation :
No Explanation available for this question

# The efficiency of a nuclear power plant in comparison to conventional and nuclear consideration is

1.  Higher cost of nuclear fuel

2.  High initial cost

3.  High heat rejection in condenser

4.  Lower temperature and pressure conditions

4

Lower temperature and pressure conditions

Explanation :
No Explanation available for this question

# A suspension bridge with a two-hinged stiffening girder is statically:

1.  Determinate

2.  Indeterminate to 1 degree

3.  Indeterminate to 2 degrees

4.  Indeterminate to 3 degrees

4

Indeterminate to 1 degree

Explanation :
No Explanation available for this question

# Consider the following statements: 1. A properly constrained rigid system has several degrees of freedom. 2. The number of degrees of freedom of a locomotive moving on a railway track is only two. 3. A floating ship has six degrees of freedom. Which of these statements is/are correct

1.  1, 2 and 3

2.  3 only

3.  2 only

4.  1 only

4

3 only

Explanation :
No Explanation available for this question

# Consider the following statements: 1. The principle of superposition will hold good for the analysis of linear structural systems only 2. The stress in a structural member due to several applied forces is the sum of the effects due to each of such forces, applied one at a time, only if the Hooke’s law hold good. 3. Internal stresses may not be caused resulting from lack of fit of a structural member. Which of these statements are correct

1.  1, 2 and 3

2.  1 and 2 only

3.  2 and 3 only

4.  1 and 3 only

4

1, 2 and 3

Explanation :
No Explanation available for this question

# For the beam-system as shown, if the slope at M is zero, then the ratio T/S is:

1.  1/2

2.  1/3

3.  1/4

4.  1/8

4

1/4

Explanation :
No Explanation available for this question

# For the beam-system as shown, if the deflection at C is zero, then the ratio P/Q is:

1.  3/8

2.  5/8

3.  3/16

4.  5/16

4

5/16

Explanation :
No Explanation available for this question

# The reaction of the beam at C is:

1.  5.5kN

2.  6.5kN

3.  7.5kN

4.  8.5kN

4

7.5kN

Explanation :
No Explanation available for this question

1.  0

2.  2 m

3.  3 m

4.  4 m

4