# The maximum ratio of span to depth of a slab simply supported and spanning in one direction is:

1.  35

2.  25

3.  30

4.  20

4

30

Explanation :
No Explanation available for this question

# The maximum ratio of span to depth of a slab simple supported and spanning in two directions, is

1.  25

2.  30

3.  35

4.  40

4

35

Explanation :
No Explanation available for this question

# The maximum ratio of span to depth of a cantilever slab is

1.  8

2.  10

3.  12

4.  14

4

12

Explanation :
No Explanation available for this question

# The amount of reinforcement for main bars in a slab, is based upon:

1.  Maximum bending moment

2.  Minimum bending moment

3.  Maximum shear force

4.  Minimum shear force

4

Maximum bending moment

Explanation :
No Explanation available for this question

# The transverse reinforcements provided at right angles to the main reinforcement.

2.  To resist the temp stresses

3.  To resist the shrinkage stresses

4.   All the above

4

All the above

Explanation :
No Explanation available for this question

# The weight of reinforced concrete is generally take as

1.  2300 kg/m3

2.  2400 kg/m3

3.  2500kg/m3

4.  2800kg/m3

4

2800kg/m3

Explanation :
No Explanation available for this question

# If the permissible compressive stress for a concrete in bending is Ckg/m2, the modular ratio is

1.  2800/C

2.  2300/C

3.  2800/3C

4.  2800/4C

4

2800/4C

Explanation :
No Explanation available for this question

# Clearance volume in actual reciprocating compressors is essential

1.  To accommodate Valves in the cylinder head

2.  To provide cushioning effect

3.  To attain high volumetric efficiency

4.  To provide cushioning effect and also to avoid mechanical bang of piston with cylinder head.

4

To provide cushioning effect and also to avoid mechanical bang of piston with cylinder head.

Explanation :
No Explanation available for this question

# Consider the following parameters with regards to slenderness ratio of a compression member: 1. Material 2. Sectional configuration 3. Length of member 4. Support end conditions On which of these parameters does the slenderness ratio of a compression member depend

1.  1, 2 and 3 only

2.  1, 3 and 4 only

3.  2, 3 and 4 only

4.  1, 2, 3 and 4

4

2, 3 and 4 only

Explanation :
No Explanation available for this question

1.  3650 mm2

2.  3450 mm2

3.  3076 mm2

4.  2899 mm2

4