A. 80Ω
B. 9Ω
C. 10Ω
D. 12Ω
If in a Wheatstone bridge the battery and Galvanometer are interchanged, the condition for balance
(A): bending of a conducting wire effects electrical resistance
(R): Resistance of a wire depends on resistivity of that material
S.I unit of electrical conductivity
Thomson coefficient of a conductor is 10μVK. The two ends of it are kept at 50<sup>0 </sup>C and 60<sup>0</sup> C respectively. Amount of heat absorbed by the conductor when a charge of 10 C flows through it, is:
When a high resistance R is connected in series with a voltmeter of resistance G, the range of the voltmeter increases 5 times. Then G:R will be
A steady current is set up in a metallic wire of non-uniform cross-section. Then the drift velocity related the area of cross-section (A) as
Thomson coefficient of a conductor is 10μV/K.The two ends of it are kept at 500C and 600C respectively.Amount of heat absorbed by the conductor when a charge of 10C flows through it is
A 25 watt,220 volt bulb and a 100 watt,220 volt bulb are connected in series across 440 volt line
A voltameter has internal resistance r ohms and range V volts.The value of resistance used in series to convert it into a voltmeter of range 4V volts is
In Potentiometer experiment,the balancing length with a cell in the secondary circuit is found to be 480cm.when a resistor of 8 ohm is connected in parallel to the cell the balancing length is found to be 420cm.The internal resistance of the cell is