A. Increases by 25%
B. Decreases by 5%
C. Increases by 50%
D. Decreases by 50%
A maximum current 0.5mA can be passed through a galvanometer of resistance 20Ω.The resistance to be connected in series to convert it into voltmeter of range 0-5V is
The cold junction of a thermocouple is at 00 C,The thermo e.m.f produced in the thermocouple is given by the equation E=16T-0.04T2V , where T is the temperature of the hot junction.The temperature of inversion and neutral temperature of the thermo couple are
Thermo emf produce per 10C temperature difference between the junction is 0.005V.when cold junction is at 100C,and hot junction is at t0C,thermo emf produced is 0.5 V.,The value of t is
In a meterbridge experiment,the balance length is 40cm.the resistance in the gap opposite to this length of wire is 8 ohm.The resistance in the other gap is
A 25 watt,220 volt bulb and a 100 watt,220 volt bulb are connected in series across 440 volt line
A potentiometer having wire of 4m length is connected to the terminals of a battery with a steady voltage.A leclanche cell has a null points at 1m,If the length of the potentiometer wire is increased by 1m,the position of the null points is
The emf of a Cu-Fe thermocouple varies with the temperature T of the hot junction, the cold junction being at 100C, as Vinμv=14T-0.02T2.Determinate the neutral temperature and the of inversion.
While connecting 6 cells in a battery in series,ina tape recorder,by mistake one cell is connected with reverse polarity.If the effective resistance of load is 24 ohm and internal resistance of each cell is one ohm and emf 1.5V,the current delivered by the battery is
A potentiometer having a 4m long wire is connected to the terminals of a battery of constant output voltage. A Leclanche cell has a balancing length of 1m. If the length of the potentiometer wire is increased by 1m, then the position of the null point is
Two wires of the same material but of different diameters carry the same current I. If the ratio of their diameters is 2 : 1, then the corresponding ratio of their mean drift velocities will be